Alta Motors Redshift MX 2017, Руководство по эксплуатации для владельца

Страница: 100 / 122

100
RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS
19. Make sure the spring pin holes in the motor plate
are aligned with their corresponding holes in the RBH.
(
Fig. 38 )
CautioN: This is impoRtaNt Not oNly FoR pRopER
aligNmENt oF thE bolt holEs, but FoR pRopER
output shaFt aligNmENt.
20. Tap the spring pins into the holes at the 12 o’clock
and 6 o’clock positions. Knock them straight in until
they are flush. (
Fig. 39 )
21. Tighten the bolts and screws in the sequence
shown to the specified torque. Note that the torque
Fig. 38
setting for the screws (9, 10) is 2 Nm,while the rest are
4 Nm. All require Loctite 243.
22. Install the oil door (if not already installed), and
tighten the screws to 2 Nm with Loctite 243. ( Fig. 40 )
23. Lubricate the countershaft bearing with the
specified gear lubricant.
24. Install gears (
SEctioN 12
)
Fig. 39
CHAPTER 6