Alstom MiCOM P50 Agile P15D, Техническое руководство

Страница: 183 / 224

P50 Agile P15D 12 SCADA Communications
P15D/EN TM/B 12-9
The IEC 60870-5-103 profile in the Menu Database contains a complete listing of all events produced
by the device.
2.2.6 General Interrogation (GI)
The GI request can be used to read the status of the device, the function numbers, and information
numbers that will be returned during the GI cycle. These are shown in the IEC 60870-5-103 profile in
the Menu Database.
2.2.7 Cyclic Measurements
The device will produce measured values using ASDU 3 or ASDU 9. ASDU3 will be reported with
information number 147 and ASDU9 is reported with information number 148 and 155. These three
frames are reported alternately. This can be read from the device using a Class 2 poll. For every query
the current online data is reported.
The device transmits its measurands at 2.4 times the rated value of the analogue value.
2.2.8 Commands
The list of commands supported P15D relay is given in table below.
2.2.9 Test Mode
It is possible to enable test mode in the relay using either the front panel menu or with P50 Agile
configurator. An event will be produced to indicate both entry to and exit from test mode. Spontaneous
events and cyclic measured data transmitted whilst the device is in test mode will have a COT of ‘test
mode’
Test mode does not disable any output contacts.
Disturbance Records
The disturbance records are stored in uncompressed format and can be extracted using the standard
mechanisms described in IEC 60870-5-103. This relay supports up-to 5 records.
2.2.10 Configuration
To configure the IED for this protocol, please see the Configuration chapter.