4.
INSTALLATION INSTRUCTIONS
Stand all three cradles bases, equal distance apart
matching the length of the four cradle support lengths.
Take some time to note the dowels at the ends of the
supports lengths, and the grooves in the cradles.
The double sided base support screw is used to
connect the end cradle base supports to the support
lengths. The longer single threaded bolt is used
between the centre cradle support.
Slide the two long bolt threads through each side on
the center cradle, so that an equal amount of thread is
remaining on each side.
If you use a tool to assist pushing the bolt through, be
careful not to damage the thread.
Slot all four cradle support lengths onto the four bolt
ends on either side of the center cradle. You should
see thread emerging through each of the pre-created
holes.
1.
3.
4.
2.
11
Bolt Thread
Double Sided Screw