Alpine STi Series Gas Fireplaces
9
WARNING: Failure to position the parts in
accordance with these diagrams or failure to use
only parts specifically approved with this appliance
may result in property damage or personal injury.
POSITIONING THE INSERT
Gently place the insert on the hearth and route the
blower wires to the back of the insert through the
blower adapter hole. Gently slide the insert into
position. Use the leveling bolts provided to adjust the
height and the level of the insert
.
Final leveling is not
required at this point.
The adapter must be attached
to the appliance while it is being positioned. Make sure
the adapter is properly attached and secured before
proceeding. See Fig. 5.
ELECTRICAL CONNECTIONS
The simplest and most effective way to get power to
the system is to run a 120V A.C. line to the right side
of the fireplace. The 120V A.C. power runs through
the fan control switch, the thermostatic on/off switch,
and also the blower motor itself. These switches are
connected in series or end to end.
GROUNDING
NOTE:
Star Washer must be placed between base
material and closed loop connector.
Note: Be sure to protect the hearth with
cardboard, thin plywood, or light sheet metal to
prevent the inset from marring , or scratching the
hearth.
Figure 5- Connecting the Appliance Adapter
VENTING REQUIREMENTS / INSERT PLACEMENT / ELECTRICAL
Attach Fastening Screw
Slide Adapter in Gently
Exhaust Vent
Intake Vent
Band Clamp
Note: Take special care not to damage the gasket
material on the appliance adapter. An improper
seal will inhibit proper operation of the fireplace
insert.
Note: The bottom trim panel will need to be
installed to adjust the height. See “Trim Panel
Installation”.
Figure 6 - Wiring Diagram
Figure 7 - Inserting the Fan
Green (Ground)
White (Neutral)
Black (Live)
Fan
White
G
re
en
Bl
ac
k
B
la
ck
W
hi
te
120 VAC
60HZ
(*by others)
(*by others)
(*
by
ot
he
rs
)
ON
OFF
Thermodisc
(*Supplied by others
install according to
local code)
Ground for
mobile home
