ALPINE HCE-C300R_EN 68-18693Z26-B (A5)
31
-EN
und
th
nd
th
t
B
ffset
s up
the
ion
s
itch
a
Performing Calibration
Measure and input calibration data carefully.
Errors can result in image distortion, guideline
misplacement, and degradation of detection
performance.
If the ignition key is turned off during calibration,
the settings will not be saved.
1
Set the SETUP switch of the control unit
to “ON.”
2
Set the ignition key to ACC ON.
The camera system starts in calibration mode.
3
Display the camera screen and press
VIEW
.
Refer to “Turning the Rear Camera On and
Off ” (page 15).
The Top menu screen appears.
•
•
•
4
Press
VIEW
, select “Change” for (cm) or
(Inch), and press
SET.
to execute.
The Graphic display range adjust screen
appears.
Execute calibration at the selected unit.
Select “Change” under “Language” in the
Top menu screen to change the display text
language. For operation instructions, refer
to the step 19.
5
Press
SET.
to adjust the display range.
Line with which to align
the end of the bumper
Adjust so that the bumper appears within
the orange adjustment frame. The bumper
should take up about 10% of the area inside
the frame.
If the bumper takes up too much space
or almost does not show at all, adjust the
installation angle of the camera to fit within
the angle range on page 18.
If the adjustment frame is set to the
bottommost position, the area outside the
camera range (black circle edge) might
be displayed in the bottom portion of the
screen. If the area outside the camera range
is distracting, set the adjustment frame one
level upwards.
6
Press
VIEW
, select “Next,” and press
SET.
to execute.
The Input Camera Position screen appears.
•
•
•
•
