Alpine HCE-C200F, Руководство пользователя

Страница: 11 / 17

10
-EN
ALPINE HCE-C200R 68-09359Z09-A (EN)
Install to the Front Bumper
1
Attach the camera to the camera
1
mounting
2
.
Pull the camera cable through to the camera
mounting
2
, and secure with the hex screws
3
.
Mounting the Front Camera (HCE-
C200F) (If HCE-C200F is purchased)
Preparation
1 Check accessory parts.
1
Front camera (1m)
2
Camera mounting
3
Hex screw
4
Hexagonal wrench
x 2
5
Cord clamp
6
Tapping screw
7
Camera extension
cable (4m)
x 5 x 4
1
3
2
Use the hexagonal wrench
4
to loosen the
camera mounting
2
and angle adjustment
screw. Determine the attachment angle, and
carefully tighten the angle adjustment screw.
3
Make a 13mm hole in the front bumper
camera mounting.
* If the tapping screw
6
is used, make a hole.
4
Pull the camera cable inside the car through
the hole made in step 3.
5
Remove the adhesive seal from the camera
mounting
2
, and attach the camera
mounting.
A Service hole
B Grommet
C Make an incision in the grommet.
• If necessary, use a tapping screw
6
to fix the camera
mounting (In the case of a plastic mount area).
6
Connect the camera cable through the
service hole to the power box.
• Attach the camera in a position where it does not touch the
number plate.
• Use retail touch-up paint to paint the surface and
surrounding area when a hole has been made in a metal
surface.
• Route all cables away from hot areas/parts of the car.
2.5
*
13
30
21
1
A
B
C
Angle adjustment screw