AlpicAir ACCMI-26HRDC1A, Руководство пользователя

Страница: 20 / 48

5.1.2 Installing the Main Body Unit
(5). Remove the gasket anchor board and tighten the nut remained.
(6). Remove the paper template.
Notes:
1.
2.
cassette unit.
Drilling of ceiling opening and installation of air conditioner must be performed by professionals!
Please refer to the installation cardboard for the dimension of drilling hole of lifting screw of
Fig.4
(1). Install the hoisting stand on the hoisting screw by using nuts and gaskets at both the upper
(2).
(3). Adjust the unit to the best position.
(4). Check if the unit is installed horizontally at four directions. If not, the water pump and the
5.1.3 Installing the Suspension Bolts
and lower sides of the hoisting stand. To prevent the gasket from breaking off, a gasket
anchor board can be helpful.
Fig.5 Fig.6
bolts with a hammer. (Fig.7)
Fig.7
15
DC Inverter Free match Series Cassette Type Unit
holes. (Fig.6)
(3). Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor
(1). Using the installation template, drill holes for bolts (four holes). (Fig. 5)
(2). Install the bolts to the ceiling at a place strong enough to hang the unit. Mark the bolt
12.7
positions from the installation template. With a concrete drill, drill for 12.7mm diameter