10
Subject to change without notice | 83059600lUK | ait-deutschland GmbH
NOTE
Always comply with the installation plan for
the respective model. Note the size and mini-
mum clearances.
Installation plan for the respective model, from
Page 24
NOTE
Install the unit so that the switch box side
(= control side) is accessible at all times.
NOTE
The noise immissions of the heat pumps must
be taken into account in the respective instal-
lation plans for air/water heat pumps. The re-
spective regional regulations must be com-
plied with.
Installation site requirements
●
Perform installation outdoors only
Clearance dimensions were complied with
“Minimum clearances”, page 24
Free air intake and blowing air are possible with-
out any air short-circuit.
The surface is suitable for installation of the unit:
●
The foundation is level and horizontal
●
The surface and the foundation have a load-
bearing capacity sufficient for the
unit’s weight
Ground surface in the air outlet area of the heat
pump is permeable to water
Unit installation
1. Align the unit base horizontally using the spirit level
and attach it to a strip foundation or full-area foun-
dation with 4 screws.
2. Unscrew the 4 levelling feet of the heat pumps by
2 turns.
3. Lift the heat pump over the unit base and place it
with the levelling feet in the holes provided in the
unit base. Push the levelling feet under the con-
striction of the holes.
4. Tighten the lock screws on the levelling feet
through the openings in the unit base using the
wrench until the heat pump is tightened firmly on
the unit base.
Heat pump installation instructions
5. Remove the two tensioning straps.
6. Open the tension lock, turn the hook on the base
plate by 90°.
90°
Heat pump installation instructions
7. Remove the two polystyrene crosspieces.
5.5 Attach the side panel, the rear
panel, the cover and the front
panel
Heat pump installation instructions
1. Fasten the rear panel.
2. Fit the cover.
3. Hook in the side panels. Fasten them in the front
at the center using a screw.
4. Attach the front panel.
5. Remove the protective film from the logo on the
front wall.
6. Remove the protective film from the logo on the
front wall.
