Alpermann+Velte RUBIDIUM, Руководство по установке

Страница: 26 / 92

Installation & Systems Manual RUBIDIUM SERIES
Page 26
Power Supply/Display/XLR-DSUB-RJ45 Adapter Module
This module is part of the delivery and fits into the appropriate double-wide slot. There is no
initial set-up or configuration of this module possible; it is not addressable via any
Rubidium
configuration tool. The serial number is located on the bottom side of the circuit board of this
module. This module has the following key features as these are usual for
Rubidium Series
modules:

Failure relay, connected to the FAIL_A and FAIL_B pins of the RLC connector at the rear of
the frame.
 Red LED (OPER) at the front indicates that the module is operating.
Overview of the main features of this module:
Power Supply
The integrated AC/DC converter delivers approximately 15 W to additional RUB1
modules in this chassis.
Display
The 8-digit display (7-segment LEDs, LED colour red, 15 mm digit height) shows data
received from the
TC_link interface.
XLR-DSUB-RJ45 Adapter
LTC signals of the
AlVelte Rubidium System or the MTD System can be
distributed using the connectors at the rear plate of this module. It is a hard-wired
distribution from RJ45 and DSUB9 connectors to two XLR3 connectors. There is no LTC
reader built-in.
For detailed information, please refer to the document “
Functional Description and Specifi-
cations D1 ”.