Step 8
Position the footrest on the lower bench supports. Note: The footrest is intended to be free-sliding, but you may secure it to the wall sections
if you wish. Now secure the bench cover to the vertical support from behind using 3.5 x 50mm screws. Next, position the bench on the upper
bench supports. There is no need to fix the bench in place, but you may secure it to the wall sections if you wish from underneath using 5x70mm
screws. Finally, level the backrest 10” above the upper bench and secure to the wall with 3x40mm screws through the pre-drilled holes.
Step 9
Locate the 5 roof support slats. Starting above the door, secure the supports in place using the 4x70mm screws through the predrilled holes.
Position them so the bottom of the supports measure 3” from the top edge of the wall panels. Lay the roof sections on the supports. There is no
need to secure the roof panels to the supports, but you may if you wish.
Image 23
Image 24 Image 25
Image 18
Image 19 Image 20
SUTTON SAUNA INSTALLATION MANUAL
page 4
Image 26
Image 27 Image 28
Image 21
Image 22