Read this entire manual through to the end before proceeding with the assembly.
ELECTRICAL REQUIREMENTS
All electrical wiring must be performed by A QUALIFIED LICENSED ELECTRICIAN. Because of the heat involved in the sauna, it is required
that you use copper wire with 90oC insulation. Do not use aluminum wire to make the connection. Consult with an electrician so you can
determine the requirements for your particular situation. All wiring must conform to all national, state and local codes and regulations and
according to the instructions provided with the heater.
Be sure the surface where you are placing the sauna is flat and level. A concrete, tile, vinyl, laminate or similar surface is suitable; placing the
sauna on carpet is not recommended. It is suggested that you lay out all of the components so that it is easy to identify the pieces once you
get started with assembly.
You will need the following tools to assemble your Sutton Sauna:
Rubber mallet
Hand
saw
Hammer
Cordless drill
Stepladder
Level
Square
Tape measure
You will find the following wood components as well as labeled bags of screws and hardware. (dimensions are approximate)
4 – Bottom rails
3 – 90° Corner posts
2 - 45° Corner posts with plastic clips
6 – 17” Wall sections without plastic clips
2 – 14” Wall sections without plastic clips
2 – 14” Wall sections with plastic clips
5 - Roof support slats
3 – Roof sections
5 – Roof trim pieces – Note: longer pieces will need trimming
2 – 22” Horizontal bench supports
2 – 30” Horizontal bench supports
2 – 10” Vertical bench-cover mounting slat
1 – Bench
1 – Footrest
1 – Bench cover
1 - Backrest
1 – Door frame
1 – Glass door
1 – Hinge kit
1 – Vent cover
1 – Heater guard
1 – Hardware kit
1 – Packet of screw hole covers
SUTTON SAUNA INSTALLATION MANUAL
page 1