NEWPORT SAUNA INSTALLATION MANUAL
page 7
from your device. The speakers are located above the ceiling and are not visible from inside the sauna.
Lighting
To turn on the overhead light, press the Light button, which will immediately turn green on the display. The color
of the overhead light will be the same as when the unit was last turned off. The light has 9 settings which display
as L1-L9. The settings are as follows: L1=white, L2=red+blue, L3=blue, L4=blue+green, L5=green, L6=green+red,
L7=red, L8=all colors, L9=fade from color to color. To change the light setting press the Light button and hold for 5
seconds. Then press the button and let go to get to the setting you’d like. The system will exit the Light function after
8 seconds.
High Temp Limit
You should never operate the infrared and traditional heaters at the same time. The infrared system will not operate if
the temperature in the room is 80°C, so be sure the room cools off after using the traditional heater before operating
the infrared heaters.
Sensor Fault Detection
An EO indicator on the display panel means there is an open circuit and you should check your circuit breaker to be
sure it is not tripped. The plug on your infrared sauna requires a 20amp dedicated circuit.
An E1 indicator on the display panel means that there is some sort of short in the circuit, and you should contact your
electrician.