NEWPORT SAUNA INSTALLATION MANUAL
page 5
Reattach the hinges to the door, tightening with the hex wrench so they are snug. Note: You may have to loosen the
screws again when the door is attached to adjust the fit of the door. Once the fit is completed you may tighten the
screws in the hinges (33). Place the door into the opening and attached the hinges to the door the same way you
did to the window. You will likely need to loosen some hinge screws on the door and/or window to align and get the
correct fit (34). Attach the magnetic door latch to the top of the door frame. Note: Do not fully tighten the door latch
until you are sure that the door will properly secure to the latch (35). Slide the metal catch over the door to align with
the magnetic door latch as shown (36).
Install the traditional heater according to the instructions in the heater manual. This will include mounting the heater
to the wall of the sauna with mounting screws, with the bottom of the heater being approximately 7” from the floor
of the sauna. Be sure that the screws are at the same height (37). Lower the heater onto the mounting screws (38).
Assemble the heater fence (39). Place the heater fence in front of the traditional heater (40).
WARNING: Never operate the infrared heaters and the traditional heaters at the same time. Operate one or the
other, depending on the type of sauna you would like to enjoy.
Image 33
Image 34 Image 35 Image 36
Image 37
Image 38 Image 39 Image 40