NEWPORT SAUNA INSTALLATION MANUAL
page 6
CONTROL OPERATION
Power On/Off
Turn on the system by pushing and holding the Power button for 4 seconds until the green lights on the display are
lit. Turn the system off by pushing the Power button a second time for 1 second. The red light on the Power button
indicate the system is turned off. All of the sauna functions will only operate when the system is on and the panel is
green.
Infrared Heater Operation
With the display on, press the Heater button, which will immediately turn green. This indicates that the infrared heater
panels are heating.
To adjust the temperature, press the Temperature (-) or Temperature (+) to raise or lower the set temperature. The
temperature is displayed in Celsius, with the lowest temperature setting being 30°C (86°F) and the maximum
temperature setting being 70°C (158°F). Pressing the temperature buttons will raise or lower the temperature by 1°
each time the button is pressed. After 8 seconds the display will indicate the actual temperature in the sauna.
The heaters can operate to a maximum of 60 minutes, and you can adjust the heating time with the Time (-) or Time
(+) buttons. You will add 1 minute to the time each time you press the Time button. After 8 seconds the display will
show the time remaining. When there are 5 minutes left in the cycle the timer will sound 3 times to remind you that
your session is ending. When the heaters turn off after 60 minutes you can reset the timer if you wish to keep the
heaters on for another cycle.
Bluetooth Function
To activate Bluetooth, press the Bluetooth button which will immediately turn green. Turn on the Bluetooth function
on our Bluetooth device and pair to BT Audio. You can now listen to music from your device and control the volume
Control panel operation
60
55
50
45
40
35
30
25
20
15
10
5
Temperature display
Temp
Time+
Bluetooth
Light control
Power on/off
Time display bar
Temperature -
Time -
Light wave
1.
Power on/off
In energized state , the system is under standby , when first press “Power on/off” button, the system is
switched on,the room temperature will display on the screen, when second press this button , the
system and all loads will be turned off.if the button color shows green means on-state,and red color
means closed
2.
Light wave function
Under the power on state,press “Light wave” button,start the light wave function ,green button means
turn on,and red means turn off,the light wavetemperature will memory last setting, time is 60 minuets
Light wave temperature setting:in light wave state,press “Temp Temperature -
”
button to adjust
the temperature,the adjustment range is 30-65 degree,every press could increase only 1 degree, if no
operation exceed 8 seconds,the screen will returns to display the current actual temperature.
Light wave time setting:in light wave state,press “Time+ Time -” button to adjust time,the adjustment
range is 5-60 minutes,every press could increase only 1 minute,When the time countdown only 5 minutes,
the buzzer alarm 3 times. if no operation exceed 8 seconds,the screen will returns to display thecurrent
actual time.
Display
Tempe)
Time(+)
Bluetooth
Light Control
Power on/off
Temperature (-)
Time (-)
Heater