NEWPORT SAUNA INSTALLATION MANUAL
page 4
Position the top horizontal frame piece, ensuring that the glass is in the grooves and the tongue fits into the groove on
the vertical frame pieces. Screw into place as shown (21). With two people, position the assembled front wall section
so that the pins align with the slots (22). Gently lift the front wall section so that the pin will insert into the large
portion of the slot at the top, middle and bottom of each side (23). Then lower the wall section so that the pin slides
into the narrow part of the slots. This will secure the front wall section to the left and right wall sections. Use a rubber
mallet if necessary, to assist in lowering the front wall section to the height of the left and right wall sections (24).
Find the heater wire connections at the top of the panels and move them so they lay to the outside of the sauna for
now. This is so that they do not interfere with positioning the roof section (25). Find the roof section and remove the
thin protective dust cover that is secured with small screws. Place the roof section over the top of the sauna and lower
between the walls so that it rests on the supports at the top of the wall sections. Note: The power boxes on the top
side of the roof should be to the rear of the sauna (26). Connect the heater wires, laying the wire into the groove that
is cut into the roof section. This will ensure that the dust cover can be reinstalled without interfering with the wires.
Be sure that the wires plugs are fully connected and seated securely into the receptacles (27). Screw the roof section
into the rear and side wall sections as shown. Use 4 screws on the rear and two on each of the side walls (28).
Feed the power connectors through the holes in the dust cover and reposition the dust cover over the roof section.
Re-attach the dust cover to the roof section (29). Find the door handle and disassemble (30). Reattach the door handle
to the holes located in the glass door. Note: Tighten screws until they are snug, but not overly tight (31). Find the two
door hinges and hex wrench and disassemble the hinges (32).
Image 25
Image 26 Image 27
Image 28
Image 21
Image 22 Image 23
Image 24
Image 29
Image 30 Image 31
Image 32