ALMAC BiBi 850 HE, Руководство по эксплуатации и обслуживанию

Страница: 96 / 157

95
CHECKS PRIOR TO USE
Prior to commissioning and before each use the machine must undergo the visual and functional checks given below. Moreover, at the
start up the machine safety condition must be also checked.
VISUAL CHECK CHECK OPERATION
•
Ensure there are no hydraulic oil leakages from
the piping or other hydraulic components
•
Ensure there are no electrical conductors cut
and/or disengaged
•
Ensure no bolts, nuts and plug ring are loose
and/or missing
•
Ensure there are no cuts and/or uneven wear on
the tracks
•
Ensure there are no damages, deformations or
cracked welds
•
Make sure the user's manual, the plates and
warning signs are present
•
Check the oil level inside the tank
•
Ensure the battery that starts up the combustion engine is
charged
•
Ensure all plates and warning signs are present and legible
•
Engage the emergency buttons to make sure no operation is
possible. Once checked the emergency buttons, restore
their position to ON.
•
Check the proper functioning of the safety devices.
•
Lift and lower the platform a few times to ensure its works
properly
•
Make sure the buzzer gets enabled during platform descent
and translation.
•
During translation, check the proper working of the brakes
by releasing the joysticks.
•
Push the buzzer and make sure it works
KEY
A. whenever the machine is used
B. daily or every 10 hours
C. weekly or every 50 hours
D. monthly or every 100 hours
E. every two months or each 250 hours
F. quarterly or every 500 hours
G. annually or every 1500 hours
H.
after long shut-down (30 days)
* Refer to the engine use and maintenance manual
ORDINARY MAINTENANCE SCHEDULE TABLE A B C D E F G H
10 50 100 250 500 1500
Visual and functional checks as specified X X
Discharge filter cartridge replacement X X
Suction filters replacement X X
Grease the runners X X
Checking the hydraulic oil level X X
Change the hydraulic oil X
Track reduction gear oil level inspection X X
Replace oil in the track reduction gear X
Check the oil level in the engine X X
Change the motor oil * (after the first 20 hours) X
Replace engine oil filter.* X X
Clean the engine air filter.* X X
Replace engine air filter.* X
Track inspection and tensioning X X
Check the condition of the tracks X X
Check the runners and sliding wheels X
Check the tightening of nuts and bolts X
Check using a torque wrench the tightening of screws and bolts for fixing of the
tracked chassis to the machine frame, the screws M16 class8.8 tightening
torque 193 Nm (after the first 50 hours)
X
Check and adjust the plug rings X
Structural inspection (visual) X X X
Structural inspection (through checking of metal parts and welds) X X
Check the overload monitoring device X X
Manual emergency devices X X
Check the combustion engine battery X X
Check the working of the differentials X X
Check the limit switches X X
Check the inclinometers X X
Check and replace the fuses X X