ALMAC BiBi 850 HE, Руководство по эксплуатации и обслуживанию

Страница: 104 / 157

103
☼
IF THE BATTERY IS CHANGED, ALWAYS COMPLY WITH THE INSTRUCTIONS
SUPPLIED WITH IT
6.9.2 Maintenance
ALMAC S.r.l. installs “ maintenance-free
” batteries as part of the standard equipment on all models.
These batteries feature construction technology that reduces water consumption to a considerable extent
and maintains the electrolyte for the entire life cycle of the batteries themselves.
6.9.3 Recharging
The batteries installed as part of the standard equipment on all models are generally equipped with an
indicator that provides information about the battery charge depending on the colour:
When charging, gas develops that in certain conditions can create EXPLOSIVE
ATMOSPHERES.
Always recharge batteries in well ventilated places that conform to standards EN 60079-10 (IEC
31-30), where there is no risk of fire outbreaks and where suitable extinguishers are ready to
hand.
Connect the battery charger to an electric power supply that conforms to the following
specifications:
•
Voltage: 230 v ± 10%
•
frequency: 50-60 Hz
•
Functional earthing system
Proceed as described below to access the battery:
1) raise the extensible structure of the platform using the relative controls (see previous pages)
2) block the extending structure using the procedure described in sec. 2.9 Safety regulations
during maintenance
3) Remove the casing of the electric panel compartment (1) using appropriate tools
4) Unscrew the cables connected to the battery terminals and insert the battery charger clamps
5) Disconnect the battery charger when the relative indicator shows that the battery is charged.
6) Comply with the GENERAL RECOMMENDATIONS described in section 6.9.1