Alltech 25L100, Руководство оператора

Страница: 60 / 65

KEENAN MechFiber 250 and
280 Operator’s Manual
60
Revision C01, 04 th Dec 2019
10. Machine is not chopping Blades blunt.
Not enough material in body
– not heavy enough –
try adding more material or in case of hay/straw add
water or a fork of silage to weigh it down.
Machine overloaded.
11: Machine breaks ASA140 link Check chain alignment of large sprocket,
Tol/- 2 mm.
Check chamfer on edge.
Check roll pins used in joiner link.
Check idler tension.
12: Bale goes in too quickly If the bale goes into the machine too quickly, it may
place unnecessary load on the tractor and drive
line, as well as slowing overall mixing time as the
body blades aren’t as efficient at chopping long
fibrous material as the top knife. Check tine buffers
and tine to top knife gap.
13: Excessive hitch wear If excess hitch wear is noted check:
-Speed of use, hitch rated for 25 km/h maximum.
-Hitch is level on tractor.
-Fit of hitch & lubrication.
-Wear on tractor hitch.
-Check brake operation matches tractor brakes.
-Excessive movement
– not tight on pin/hitch.
14: Leaking valve chest (where fitted)
Check oil is only flowing from pressure “P” side to
tank “T” side. Reverse pressuring the valve check
will damage the seals. The addition of a one-way
valve on the return pipe will prevent this.
15: Leaking oiler If oiler leaks or loses oil, check the one-way valves
in oiler housing. Fit restrictor fitting to pressure line
which will smoothen out any power surges in the
line and protect servo.
16: Excess oil on chains Adjust oiler
– the volume of oil sent to the chains
when the guillotine door is operated may be
adjusted by turning the set screw on the base of the
oiler.
The oiler operates on the closing stroke of the
guillotine door, therefore the drive line should be left
running for a period after the guillotine door is
closed to allow the oil cover the full chain.
17: Blockage at top knife On non-Bale Handler models, load smaller sections
of material into machine
On Bale Handler models check tine height settings
Ensure all feed materials are free from foreign
objects before loading into machine
In the unlikely event of a large blockage occurring
which prevents the machine from restarting using