Alltech 25L100, Руководство оператора

Страница: 11 / 65

KEENAN MechFiber 250 and
280 Operator’s Manual
11
Revision C01, 04 th Dec 2019
d) Exercise extreme caution for possible overtaking traffic at either side when turning.
e) Do not stand on the ladder while the feeder is in transit. The mixer wagon should never
be used for the transport of people, animals or objects.
f) Do not stand between the tractor and mixer wagon while it is in use.
g) Use only a PTO shaft with a properly fitted safety guard and correct shear bolt.
h) Always connect the PTO shaft with the shear bolt end to the machine. The operating
speed of the PTO is 540 rpm, and the direction of rotation is marked on the front cover.
Always use a well-maintained PTO shaft and keep the safety covers in good condition.
i) Ensure all trailing leads, hoses, etc. are well clear of the PTO.
j) Never operate the PTO in
“ground speed mode” or drive the PTO in reverse.
k) Make sure all covers/guards are fitted and closed correctly. Never remove guards when
the mixer wagon is connected to the tractor.
l) Ensure the mixer wagon and the immediate area surrounding it is clear of people,
especially children, before commencing operation. Ensure that there is sufficient
visibility for the operator to observe all danger zones and that the tractor is equipped
with mirrors to enable the operator to see both sides of the machine while it is in
operation.
m) When connecting the tractor to the mixer wagon, only connect using the ring hitch/hitch
on the mixer wagon to ensure safe coupling. Ensure that the hitch is connected properly
to the tractor and that all pins and clips are properly installed. Then connect the PTO
shaft in the correct fashion. Connect the hydraulic hoses ensuring that the functions
match the indicated valve on the tractor.
n) When disconnecting always ensure that a stand or jack is used to secure the mixer
wagon in the park position and ensure that the handbrake is properly applied. Before
driving the tractor away from the mixer wagon ensure that all hoses and cables are
disconnected.
o) Load only from the side indicated
— see figure 7 (auger chamber side), using suitable
equipment.
p) Standing level with or above the machine in order to load manually is not permitted.
Loading should only be carried out with suitable equipment.
q) Regularly inspect all chains (at least weekly), sprockets and moving parts for wear and
check all nuts and bolts for tightness.
r) The ladder on the rear of the mixer wagon is to be used as a viewing point for the mixing
chamber. It should not be used as a means of access to the mixing chamber nor onto
the body of the machine. It is strictly forbidden to climb on the upper rim of the machine
body. The height of the machine presents a potential fall hazard during entry and exit.