SZD-54-2
„Perkoz”
TECHNICAL SERVICE MANUAL
SECTION 2.
ASSEMBLING & DISASSEMBLING,
SYSTEMS DESCRIPTION
Issue II
April 2014
Revision No. 2
May 2017
Allstar PZL Glider Sp. z o.o.
Doc No. 542.4.02
page 2.41
corrected
2.20. Battery and equipment mounting in luggage compartment
On the glider, for additional equipment power supply, the battery can be
mounted in the luggage compartment (Fig. 2
‒22.) or in the tail (Fig. 7‒4.).
It is
permissible
to install an additional battery, next to the first one, by drilling
the appropriate holes in the reinforcement plates in the floor (position as shown in the
figure below).
Fig. 2-22. Battery mounting in sailplane luggage compartment
On the
floor
of the luggage compartment it is possible to install additional
equipment of total weight (including two batteries) up to 44 lb. The floor at the
mounting bolts of the equipment should be strengthened as follows:
In screws designated areas cut out at least 0,
8” diameter of lower skin and
foam core of the floor leaving upper skin intact. Paste adapted to cut glass fibre
composite 0,24
” thick plate on aerosil thickened composition in cut foam place. Skin
should be repaired by one layer 92125 fabric arranged obliquely with 1,
2” overlap
according to repair instructions in Section 17.
Prepared reinforcements may be loaded with weight distributed over several
attachment points, a value of 2,2 lb at single point.
2
2
2
2
