14 / 16
6-1624982 - rev.1 - 20/05/2021
ENG
6.5 ADJUSTMENT OF INTERNAL MECHANICAL STOPPERS (OPTIONAL)
+
-
MECHANICAL STOP
OF CLOSING
MECHANICAL STOP
OF OPENING
To adjust the internal mechanical stoppers (optional), proceed as follows:
1.
Unlock the motor and manually open the gate to the position of "OPEN DOOR".
2.
Approach a magnet (not supplied) or one of the washers provided in the kit on the motor body at the opening mechanical
stopper until you find the point where it remains attached. In this way the magnet is located exactly at the mechanical stopper
position and will be useful to understand which mechanical stopper you are acting by adjusting the screws and in which
direction you are moving it.
3.
Act on one of the two adjustment screws to find which of the two moves the magnet.
4.
Adjust the correct screw founded so as to carry the magnet, and therefore the mechanical stopper, as far as possible from
the gate hinge.
5.
Repeat the operations described above also for the mechanical stopper of closing, bringing the gate first in the position of
"CLOSED DOOR" and then acting on the other adjustment screw so that the magnet positioned on the closing mechanical
stopper is as close as possible to the gate hinge.
6.
Lock the motor.
After the adjustment, before connecting the motor to the control unit, make sure that manually moving the gate does not go beyond
the desired limit positions. If so, repeat the procedure described above.
MAGNET
WARNING!
If the motor is installed in such a way that the opening of the gate takes place towards the outside, reverse the refe-
rences of this procedure with respect to the nomenclature of the mechanical stoppers.
In detail, the mechanical stopper that is closest to the motor body will be the MECHANICAL STOP OF CLOSING, while
the farther one will be the MECHANICAL STOP OF OPENING.
MECHANICAL STOP
OF OPENING
MECHANICAL STOP
OF CLOSING
