Allmand Maxi-Power MP25 T4F, Руководство оператора

Страница: 28 / 68

Not for
Reproduction
28 ALLMAND.COM
3. Operation
3-15
Check frequency and voltage
<Procedure>
1. After warming up, display Generator monitor and press ▲▼ to show [Generator Frequency].
Check that the frequency of the generator is at 60Hz after warm up. (See 3-2)
Monitor Screen
2. Press ▲▼ to show [Generator Voltage] and adjust to rated voltage with a voltage adjuster [F].
Display Voltage Adjuster
Operation with Load
<Procedure>
1. Set the circuit breaker [A] to [ON] and supply power to the load.

During operation, check and confirm whether the generator functions properly. (See. 3.5.2)
※
Before starting to supply power to the load, make sure that the voltage is in accordance with the load.

After the engine starts up, warm it up unloaded for approx. 5 minutes.

Warming up after starting up is necessary for smooth operation of the engine.
Do not operate the engine at full load immediately after it starts up.
This will shorten the equipment life.

During the warm-up operation, examine the different parts of the equipment for any looseness, leakage
of water, oil, fuel, and other irregularities.
 Also, make sure that the alarm lamps are off.

Be sure to operate the generator at the rated frequency, irrespective of the load capacity.
If the machine is operated with a frequency lower than the rated frequency, it could cause the generator
main machine or to be burned.
<Shutdown Procedure>
1. Stop the load.
2. Set the circuit-breaker [A] to [OFF] position.
3. After about 5 minutes cooling down operation, push the stop button [G] to stop the engine.
4. Set the power control switch [B] to [OFF] position.
※
The engine controller is on for a few minutes after engine is stopped. Do not remove the battery cables,
etc., during this period.