Allmand Maxi-Power MP25 T4F, Руководство оператора

Страница: 25 / 68

Not for
Reproduction
25
3. Operation
3-12
3.4.6 Check Interior
Periodically check the inside of the generator for dust and flammables

Please wear personal protective equipment, such as a helmet, safety glasses, earplugs, safety shoes,
gloves, and a mask as appropriate to the work environment.
 Periodically check the inside of the generator for dust and flammables. When any flammables such as
chips of wood, dead leaves (dry leaves) and waste paper are left near heated exhaust muffler and heated
exhaust pipe, all of them should be removed
.

Keep a fire extinguisher available by the machine in case of unexpected fire.

It is advisable to have a list of phone numbers of doctors, ambulance and the fire department available in
case of emergency.
3.4.7 Check Belt Tension
A010181
Adjust the alternator belt by the following procedure:
Unfasten the mounting bolts and nuts of the alternator to adjust the alternator belt.
<Procedure>
1. Visually check there are no cracks or wear or other damage to the
belt.
2. Belt tension is adjusted by loosening the alternator mounting bolts
and nuts. While pressing the center of the belt slightly, adjust belt
tension by loosening fitting bolt so the amount of deflection is
between 6 and 6.5mm (98 N).
3.

If there is any oil or coolant on the belt, wipe it off completely
during service.
Refer to engine instruction manual for more details for belt
adjustment.
TR0304
 Be sure to stop the engine whenever the tension of the belt is to
be adjusted.
 Remove the negative (–) side cable from the battery.
 If the machine is running, it might catch the operator’s hand into
the belts, and this could cause a serious injury.
 Be sure to stop the engine whenever inspections and
maintenance near the cooling fan.

If the machine is running, it might catch the operator’s hand into
the fan, and this could cause a serious injury.

Over-tensioning of the belt leads to shaft breakage and reduced bearing life. If it is too loose, belt
slippage may lead to premature breakage of the belt or damage to the machine due to overheating.
Press the center
Alternator
Amount of
deflection 6-6.5mm