Allied AutoLube II, Техническое руководство

Страница: 19 / 28

SECTION 7.0
TROUBLESHOOTING
~
WARNING
Before removing the hydraulic lines,
bleed all hydraulic pressure.
When rectifying faults, observe all
safety regulations.
A
llied
AutoLube II
11/1/03 15
Problem Cause Remedy
No Lubrication at
Lubrication Point
Lubricant cartridge
empty. Install new cartridge.
Air in lubricant lines. Bleed system of air
(refer to Section 6.3).
Pressure oil line to
system is blocked. Open branch from ham-
mer pressure line (valve
block on boom).
Pressure oil line to
system leaks. Check fittings and hose:
replace if necessary and
tighten properly.
Lubricant line blocked or
too long. Check hose, replace if
necessary (maximum
length 15 feet). Perform
functional test with hose
uncoupled.
Lubricant cartridge in-
stalled incorrectly. Reinstall cartridge
correctly (refer to Section
6.2); check sealing sleeve,
replace if necessary.
Lube system draws in air. Seal between cartridge
and pump housing defec-
tive. Replace seal.
Check valve in pump
housing defective. Replace check valve.