Allied AutoLube II, Техническое руководство, Страница: 14 / 28

6. Bolt AutoLube II to hammer with
M12-1.75 bolts and M12 lock washers:
·
O n m o d e l s w i t h b r a c k e t , b o l t
AutoLube II to bracket.
·
On models with slot in hammer box,
slide clamp plate over hoses and posi-
tion clamp plate on the inside of the
box aligning it with the slot. Install
bolts through clamp plate, box, and
AutoLube II.
7. Connect hoses to AutoLube II pump
with adapters and 90
o
elbows:
·
Elbow (7), #4JIC, for lubrication con-
nection.
·
Elbow (8), #6JIC, for hydraulic con-
nection.
·
Adapter (9), #4JIC, for lubrication
connection.
·
Adapter (10), #6JIC, for hydraulic
connection.
8. Prime AutoLube II pump with a
hand-held grease gun at lubrication fit-
ting on pump.
9. Screw Allied Chisel Paste cartridge into
AutoLube II pump. The cartridge can be
refilled and re-used.
5.2 RETROFIT KIT
1. On retrofit kit installations, cut hose to
length and install re-usable fittings (not
shown).
2. Install #4JIC re-usable fitting into el-
bow (7) for lubrication connection.
3. Install #6JIC re-usable fitting into el-
bow (8) for pressure connection.
4. Install adapter (10) into hammer hy-
draulic pressure hose. A check valve is
supplied in the hose for this connection.
A
llied
AutoLube II
10 11/1/03
Lube
(Stamped CL)
Pressure
(Stamped P)
1
2
3
4
5
6
8
10
7
9
Connect
to
Autolube
II
pressure
port
on
Hy
-Ram
Connect
to
lubrication
port
on
Hy
-Ram
Figure 5-1. AutoLube II Installation