Allied Telesis AT-8100L/8POE, Руководство пользователя

Страница: 33 / 330

AT-8100 Series Version 2.2.5.0 Web Interface User’s Guide
33
When the Switch
Does Not Display
the Login Page
When the switch does not display the web interface, even though you
enter the IP address of the switch on the web browser, you must enable
HTTP or HTTPS service on the switch through the CLI by performing the
following steps:
1. “Logging onto the CLI through the Console Port” on page 33.
Or
Log onto the CLI using the Telnet or SSH protocol.
Note
To start a Telnet or SSH management session, see the AT-8100
Series Version 2.2.5.0 Management Software Command Line
Interface User’s Guide.
2. “Checking the Status of HTTP and HTTPS Services in the CLI” on
page 34.
3. “Enabling HTTP or HTTPS Service in the CLI” on page 35.
4. “Saving your Changes in the CLI” on page 36.
Logging onto the
CLI through the
Console Port
To log onto the CLI through the console port on the switch, perform the
following procedure:
1. Connect the RJ-45 connector on the management cable to the console
port on the switch.
2. Connect the other end of the cable to an RS-232 port on a terminal or
a PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:

Baud rate: 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None
4. Press Enter.
You are prompted for a username and password.
5. Enter a username and password. If this is the initial management
session of the switch, enter “manager” as the username and “friend” as
the password. The username and password are case-sensitive.