Allied Systems LONG REACH FLN Series, Инструкция по установке, обслуживанию и ремонту

Страница: 27 / 40

45-009 REV. 8/20
27
5.1 Schedule
Daily:
1. Visually inspect all hoses, fittings, cylinders, and valves for signs of hydraulic leaks.
2. Visually inspect for external damage or cracks.
3. Check lower hooks for proper clearance. Maximum clearance is 3/16 of an inch.
4. If the attachment is equipped with quick change hooks check the retaining pin for
engagement.
40 Hour Maintenance:
1. On the bronze top hooks check grease fittings to ensure that they are clean and
properly working. Apply grease if needed.
2. Appy grease to face of the upper and lower fork bars.
3. Inspect any forks that contact the ground. The fork blade and shank must be
throughly checked for wear, especially near the heel. If heel thickness is reduced
to 90% of the original, replace the fork.
100 Hour Maintenance:
1. Complete the above daily checks.
2. Check all hoses and fittings for wear or damage. Inspect for hydraulic leaks.
3. Check for loose or missing bolts.
4. Check wear on the bronze top hooks. Bronze top hooks should be replaced when
the clearance between the bottom hook and the carriage is greater than 3/16 of an
inch, or when wear on the mid plate becomes visible.
250 Hour Maintenance:
1. Check the torque on all bolts securing the bronze top hooks, upper retainers and
lower hooks per the torque specification chart below. Figure 5-1
Recommended Grease:
Mobile XHP222 Special or similar quality EP-2 with Lithium Complex Base.
SECTION 5 MAINTENANCE SCHEDULE