Alliance Laundry Systems PD3JGBGS403UG01, Программирование

Страница: 14 / 40

Entering the Manual Mode
For programming, testing, and retrieving information from the
control, it is often necessary to enter the Manual Mode by follow-
ing the steps below.
For an overview of entering the Manual Mode, refer to the flow-
chart.
How to Enter the Manual Mode
1. If accessing Diagnostic Tests, be sure the dryer is in the
Ready Mode before continuing to step 2. If the dryer is in an
active cycle, rapid advance through the cycle. Refer to
How to
Enter Rapid Advance During an Active Cycle . If coins or a
card has been entered, refer to Clear Vend Feature.
2. Coin Models through Serial No. 1810000001 – Open the
service door. The coin vault switch must be closed to enter the
Manual Mode.
3. All Other Models: Unplug bullet connector.
4. While pressing and holding the HIGH TEMP keypad with
one hand, press the MED TEMP keypad with the other hand.
5. The display will show
rAPid
.
6. Press the LOW TEMP (
∧
) or the DELICATES (
∨
) keypad to
scroll through the options until the desired option appears in
the display.
7. Press the START (enter) keypad to enter the displayed mode.
8. To exit, press the MED TEMP (<) keypad. The control will
revert back to Ready Mode.
Manual Programming can only be turned on or off with an exter-
nal device or a network. Refer to the appropriate instruction man-
ual. Manual Rapid Advance and Diagnostics can be turned on
and off using an external device by manual programming (refer
to
IR Access (On/Off) irA En or Manual Rapid Advance rAPdEn ),
or with the network.
By default, Manual Programming is turned on.
The manual features available in each group are as follows (the
menu displayed on the display in this mode is in parenthesis).
Rapid Advance (
rAPid
)
Manual Programming (
Prog
)
Manual Read Audit (
AUdit
)
Manual Reset (
rESEt
)
Diagnostic Tests (
diAg
)
If a manual parameter is turned off or unavailable (i.e. attempting
to enter diagnostics while a cycle is running), the display will
change from the selected feature to
oFF
, an audio signal will
sound for one second and the features in the parameter cannot be
entered. The display will then return to the selected feature.
Entering the Manual Mode
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
14 Part No. D515810ENR3