Alliance Laundry Systems LTS97A*N2802, Сервисная инструкция

Страница: 62 / 128

60
801805
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
43. WASHER FRONT PANEL
a. Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 16.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
b. Grasp loading door seal lip. Refer to Figure 14,
Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
c. Using a circular motion, pull seal up
(Figure 14, Step 1), out (Figure 14, Step 2), and
down (Figure 14, Step 3).
d. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
door opening. Refer to Figure 14, Step 4.
NOTE: The ease of installation of the loading door
seal can be improved using water or soapy solution
to work seal around circumference of loading door.
Be sure to orientate seal with the tab in the
12 o’clock position when installing the wire clamp
ring to front panel. Be careful not to overstretch
tension spring.
e. While supporting lower access panel, remove
two screws from bottom edge of lower access
panel. Refer to Figure 8.
f. Gently lower access panel to disengage panel
locators from bottom edge of front panel.
g. Using the special tool, No. 318P4, remove the
dispenser drawer. Refer to Figure 13.
h. Remove screws holding control panel to
control cabinet.
i. Remove control panel away from control
cabinet as far as wires permit. Refer to Figure 7.
j. Working through control panel opening,
remove two screws holding bottom flange of
control cabinet sides to top flange of front
panel. Refer to Figure 15.
k. Remove bottom two front corner screws. Refer
to Figure 15.
l. Remove front panel (with loading door
attached) away from washer as far as wires
permit.
m. Unplug wire harness from both the door latch
switch and from the door switch. Refer to
Figure 15. Remove clips holding wire harness
and door seal hose along top flange of front
panel and remove front panel.
NOTE: Door seal hose and wire harness must be
reinstalled in the appropriate clips and holes along
top flange of front panel. Refer to Figure 18.
IMPORTANT: Before reinstalling door and front
panel assembly, make sure the door catch lines up
with the door latch switch. If adjustment is
required, refer to Paragraph 83.