Alliance Laundry Systems LTS97A*N2802, Сервисная инструкция

Страница: 112 / 128

110
801805
Section 6 Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
83. WASHER DOOR CATCH
NOTE: When repairing a broken or inoperative No.
685430 Door Catch, proceed as follows:
a. Remove door bezel.
b. Remove two screws and nuts holding door
catch to door and remove door catch.
c. Install new door catch and tighten screws and
nuts to the point of being snug.
d. Adjust door catch so the outside edge is aligned
with the edge of the latch. Refer to Figure 61.
e. Visually check that the door catch properly
engages the funnel of the door latch/switch
assembly. Refer to Figure 61.
f. Recheck the alignment in step “d”. Adjust if
needed.
g. Torque the two nuts to approximately 30 inch
pounds (3.4 Nm).
h. Reinstall door bezel.
Figure 61
H250SE3A
685429
Door Lock
Funnel
Door
Catch
685430
Catch
SHOWN CLOSED
Alignment of
These Two Edges