Alliance Laundry Systems LTS97A*N2802, Сервисная инструкция

Страница: 66 / 128

64
801805
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
45. WASHER DOOR SEAL AND HOSE
ASSEMBLY
a. Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 13.
b. Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 16.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
c. Grasp loading door seal lip. Refer to Figure 14,
Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
d. Using a circular motion, pull seal up
(Figure 14, Step 1), out (Figure 14, Step 2), and
down (Figure 14, Step 3).
e. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
door opening. Refer to Figure 14, Step 4.
f. Remove screws holding control panel to
control cabinet.
g. Remove control panel away from control
cabinet as far as wires permit. Refer to Figure 7.
h. Reach in through control panel opening and
remove two screws holding bottom front flange
of control cabinet sides to top flange of washer
front panel. Refer to Figure 15.
i. While supporting lower access panel, remove
two screws from bottom edge of lower access
panel. Refer to Figure 8.
j. Gently lower access panel to disengage panel
locators from bottom edge of front panel.
k. While supporting the front panel assembly,
remove the two bottom front corner screws.
Refer to Figure 15. Remove front panel (with
loading door attached) away from washer as far
as wire permit.
l. Unplug wire harness from both the door latch
switch and from the door switch. Refer to
Figure 18. Remove clips holding wire harness
and door seal hose along top flange of front
panel and remove front panel.
m. Loosen hose clamp and remove door seal hose
connection at the dispenser. Refer to Figure 18.
n. Cut hose tie strap that holds door seal to
dispenser plate.
IMPORTANT: When installing door seal hose, pull
hose tie tight to prevent damage. Refer to Figure 18.
o. Loosen large clamp holding seal to front of
outer tub. Slide seal off front of outer tub and
remove seal.
NOTE: The ease of installation of loading door seal
can be improved using water or soap solution to
work seal around the circumference of loading
door. Be sure to orientate seal with tab in the 12
o’clock position when installing wire clamp ring to
the front panel. Be careful not to overstretch tension
spring.