505872
55
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
(3) Hold motor pulley securely and unthread
impeller from motor shaft. (Right hand
thread.) Use a 7/8 inch, 6 point socket to
aid in the removal of the impeller.
(4) Remove three screws (and washers if
present) holding the exhaust housing to the
motor mounting bracket. Refer to
Figure 30.
k. Motor
(1) Disconnect wires from motor switch. Refer
NOTE: Refer to appropriate wiring diagram when
rewiring motor switch.
(2) Disconnect ground wire from motor. Refer
(3) Pry two motor clamps off motor mounting
bracket with screwdriver. Refer to
Figure 29. Then lift motor out of mounting
bracket.
NOTE: When replacing motor, motor switch
location should be at 10 o’clock position with the
positioning tab on the motor engaged with the notch
in the motor bracket. Refer to appropriate wiring
diagram when rewiring motor switch leads.