62
M413438
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
78. DOOR SWITCH ROD
Refer to Figure 36.
a. Remove control panel.
b. Unlock, open and remove lint panel. Set aside
to prevent damage.
c. Open loading door, support door and remove
upper hinge bolt holding door to hinge bracket.
Refer to Figure 32.
NOTE: Nylon washer must be in place on lower
hinge pin when reinstalling door.
d. Remove door from bracket.
e. Support front panel and remove screws (and
three speed nuts — newer models only) holding
front panel to tumbler cabinet. Refer to
Figure 34.
f. Remove front panel.
g. Remove nut, washers and spring clip holding
switch rod to back side of front panel.
NOTE: When removing front panel, lower panel
slightly to make sure door switch rod clears hole in
cabinet.
Figure 36
T034SE1A
SWITCH
ROD
SPRING
CLIP
