Installation
Before You Start
Tools
For most installations, the basic tools you will need are:
D818I_SVG
5
4
3
2
1
1.
Wrench
2.
Screwdrivers
3.
Level
4.
Duct Tape
5.
Teflon Tape
Figure 1
NOTE: An 8 in. [20.32 cm] coin drawer is required for
coin operated MDC and NetMaster models with stand-
ard capacity meter case and high capacity meter case
models starting with Serial Nos. beginning 1010. High
capacity meter case MDC and NetMaster models with
Serial Nos. beginning 0910 through 1010 require a 7.21
in. [18.31 cm] coin drawer.
Card Reader Models
The machine is shipped from the factory with the Electronic Con-
trol Diagnostic Harness Assembly unplugged. To avoid unauthor-
ized manual programming or vending, perform the following
steps.
1.
Open service door. Refer to
Figure 2
.
2.
Locate diagnostic harness on electronic control.
3.
Plug connectors for “white/black” wire and “red/blue” wire
together.
FLW6R_SVG
1
1.
Service Door
Figure 2
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
W299
Order of Installation Steps
1.
Position and level the dryer.
2.
Connect dryer to exhaust system.
3.
For gas models only, connect the gas supply pipe. Check for
gas leaks.
4.
For electric models only, connect the electrical cord.
5.
Reverse the door, if desired.
6.
Wipe out the inside of the dryer.
7.
Plug in the dryer.
8.
Recheck steps.
9.
Check heat source.
Position and Level the Dryer
1.
Install dryer before washer. This allows room for attaching
exhaust duct.
2.
Install the four rubber feet (in accessories bag).
3.
Select a location with a solid floor. Dryers installed in resi-
dential garages must be elevated 18 inches [457 mm] above
the floor.
No other fuel burning appliance should be installed in the same
closet with the dryer.
Installation
Part No. 512680R10
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
14
Содержание D677I_SVG
Страница 2: ......
