19
Assembly and Installation Instructions
22)
Ensure the warning placard is correctly positioned: Refer to the photos in Step #21
for confirmation.
On the end with the warning label, locate the buckle at the top of the net, and count 5
meshes away from the strap buckle at the end of the net. Your net may have a red
thread sewn into the top strap at this location; you may use this as a reference instead
of counting.
Keep in mind, this number is approximate
, and the net may need to be
adjusted so that the doorway is centered between poles 6 and 1.
Hang the top of the net from the ball end cap, beginning at the enclosure pole to the
right of the doorway (Pole 1). Continue to hang the top strap of the net from the enclo-
sure poles in a counter-clockwise direction. The top strap will not be perfectly straight
between poles.
23)
Continue hanging the net around the circumference, back to pole 1. Thread the loose end of the net strap through
the inner slot in the buckle, then over the center divider, and back out through the outer slot as shown in photos
A
and
B
above to join the two sides of the net. The strap should exit the buckle behind the buckle tab as shown in photo
B
above.
Tighten the top and bottom straps most of the way, but leave the net slightly loose.
Note:
Bottom of net may not be touching trampoline at this time. This is normal.
A
B
Pole 1
Pole 2
Pole 3
Doorway of trampoline
Pole 6
5 net meshes from strap buckle
No gap between cap and
foam/sleeve
View from inside trampoline looking outward
Pole 1
