3
HARDWARE CONTENT
(shown actual size)
AA
BB
DD
CC
EE
FF
GG
HH
II
Cable tie
Qty. 2
Drywall Anchor
Qty. 4
Wire Nut
Qty. 3
Mounting Screw
Qty. 2
Plastic push-in
fastener
Qty. 1
Machine screw
Qty. 2
Machine screw
Qty. 2
Wood Screw
Qty. 4
Washer
Qty. 4
SAFETY INFORMATION
WARNING
CAUTION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
• Do not look directly at LEDs for extended periods of time.
• For INDOOR Damp Locations.
• For electrical requirements, see fixture. Minimum 90°C supply conductors.
• NOTE: THIS FIXTURE IS DIMMABLE BY SPECIFIC FORWARD PHASE ELECTRONIC (TRIAC) DIMMERS. Dimmers tested to be compatible
with this fixture are the Lutron: Skylark
®
SCL-153P*, Diva
®
DVCL-153P*, Maestro
®
MACL-153M*, Toggler
®
TGCL-153P*, Lumea
®
LECL-153P*,
Caseta
®
PD- 6WCL*, Eaton Halo
®
SAL06P*. (This list of dimmers does not imply any guarantee or warranty of compatibility with a particular
application. Dimmers not listed do not imply non-compatibility.)
Do not leave bare wires exposed.
Shut off power at the circuit breaker or fuse panel before removing the old fixture or installing a new one.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
• If you are unsure if the electrical box is properly grounded, if the box is plastic and has no ground wire, or if you are unfamiliar with the methods of
properly grounding fixture, consult a qualified electrician.
• NOTE: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: 1) Reorient or relocate the receiving antenna. 2) Increase the separation
between the equipment and receiver. 3) Connect the equipment into an outlet on a circuit different from that of the receiver. 4) Consult the dealer or
an experienced radio/TV technician for help.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any
part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 45 minutes
Tools Required for Assembly (not included): Ladder,Safety goggles,Phillips screwdriver,Power drill with 1/8 in. / 0.3 cm drill bits,Gloves
Helpful Tools (not included): toggle bolts
