124
Rockwell Automation Publication 1769-UM021G-EN-P - October 2015
Chapter 6
Communicate over Networks
Available Software
Use the software that is listed in the following table with a CompactLogix 5370
controller on an EtherNet/IP network.
EtherNet/IP Network Functionality on CompactLogix 5370
Controllers
The CompactLogix 5370 controllers offer this EtherNet/IP network
functionality:
•
Dual built-in EtherNet/IP network ports
•
Support for the following EtherNet/IP network topologies:
–
Device-level Ring Network topology
–
Linear Network Topology
–
Star Network Topology
•
Support for CIP Sync technology
•
Support for Integrated Motion over an EtherNet/IP network - Only the
following controllers support this functionality:
–
1769-L18ERM-BB1B
–
1769-L27ERM-QBFC1B
–
1769-L30ERM
–
1769-L33ERM
–
1769-L36ERM
Software
Required Version
Functions
Required
RSLogix™ 5000
Version 20
- For CompactLogix 5370
controllers that are using firmware revision
20.
•
Configure the CompactLogix project.
•
Define EtherNet/IP communication.
•
Change IP address for devices on network,
including the CompactLogix 5370
controller.
Yes. Studio 5000® environment,
version 28 or later - For 1769-L19ER-
BB1B controllers
Studio 5000
environment
Version 21 or later - For CompactLogix 5370
controllers that are using firmware revision 21
or later.
(1)
RSLinx® Classic
2.59.00 or later
CompactLogix 5370 L2 controllers require
RSLinx Classic software, version 2.59.01 or
later.
The1769-L19ER-BB1B controller requires
RSLinx Classic software, version 3.74.00
•
Assign or change IP addresses to devices
on an EtherNet/IP network.
•
Configure communication devices.
•
Provide diagnostics.
•
Establish communication between
devices.
BOOTP/DHCP
utility
Most current version is installed with
RSLinx Classic software installation.
Assign IP addresses to devices on an EtherNet/
IP network.
No
(1) If you are using the L19 you must have at a minimum, Studio 5000, version 28. There is no version of RSLogix 5000 (version 20) for support of the L19.
