Owner’s Manual
29
Finish Nailer (cont’d)
Triggering options
This tool is shipped from the factory with a “single sequential actuation”
trigger. A “contact actuation” trigger is available. The “contact actuation”
trigger allows the tool to be fired in either of the two following methods:
Single sequential actuation trigger
This method provides the most accurate fastener placement. To fire:
1
Grip the tool firmly to maintain control.
2
Position the nose of the tool against the work surface.
3
Depress the safety
4
Squeeze the trigger to fire a fastener.
5
Allow the tool to recoil away from the work surface as the fastener is
driven.
Contact actuation trigger
This method allows very fast repetitive fastener placement. To fire:
1
Grip the tool firmly to maintain control.
2
Squeeze and hold the trigger.
3
Push the tool firmly against the work surface.
4
Allow the tool to recoil away from the work surface as fastener is driven.
5
If the safety element is allowed to recontact the work surface before the
trigger is released, an unwanted fastener will be fired. The tool will fire a
fastener each time the safety is depressed.
