Compressor w/Nailgun
26
Compressor (cont’d)
Storage
Before storing the air compressor, make sure you do the following:
1
Review the “Maintenance” section on the preceding pages and perform
scheduled maintenance as necessary.
2
Set the ON/AUTO/OFF lever to “OFF” and unplug unit.
3
Turn the regulator counterclockwise and set the outlet pressure to zero.
4
Remove the air tool or accessory.
5
Pull ring on safety valve, allowing air to bleed from the tank until tank
pressure is approximately 20
psi. Release safety valve ring.
6
Drain water from air tank by opening drain valve on bottom of tank.
7
After the water has been drained, close the drain or drain valve.
8
Protect the electrical cord and air hose from damage (such as being
stepped on or run over). Wind them loosely around the compressor
handle.
9
Store the air compressor in a clean and dry location.
WARNING! WATER WILL CONDENSE IN THE AIR TANK. IF NOT
DRAINED, WATER WILL CORRODE AND WEAKEN THE AIR TANK
CAUSING A RISK OF AIR TANK RUPTURE.
Note: If drain valve is plugged, release all air pressure. The valve
can then be removed, cleaned and then reinstalled.
