Owner’s Manual
27
Finish Nailer
This is a heavy duty pneumatic finish
nailer that has been designed to drive
18 ga. finish nails of various lengths
from 5/8” to 2”.
Power Source
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 70 and 120 PSI (4.8 to 8.3 bar). The preferred system
includes the following components:
Filter
Pressure regulator
Automatic oiler located as close to the tool as possible (preferably within
15 feet.
All compressed air contains moisture and other contaminants that are
detrimental to the tool’s internal components. An air line filter removes most
of these contaminates and significantly prolongs the life of the tool. If an in-
line oiler is not available; place five or six drops of All Power America Air Tool
Oil into the tool’s air inlet at the beginning of each workday.
This tool is equipped with a ¼” male quick connector. A 3/8” male “quick
connector” is available from All Power America and may be used in situations
where a ¼” supply line is not available. A 3/8” supply line (and fittings) are
required for maximum tool performance. Always connect the tool to the air
supply with a coupling that removes all pressure from the tool when the
coupling is disconnected.
