ALL-O-MATIC APS1000-12, Руководство пользователя

Страница: 11 / 24

APS1000-12
APS2000-24
AC Input/Output Connection
Caution!! Before connecting AC input power source, please install a separate AC breaker
between inverter and AC input power source. This will ensure the inverter can be safely
disconnected during maintenance and fully protected from over current of AC input. The
recommended AC breaker is 30A for both APS1000-12 and APS2000-24 models.
Caution!! Please don’t connect the output AC to “Grid” terminals nor connect the grid to the
“Load” terminals. Doing so will permanently damage inverter.
WARNING! All wiring must be performed by a qualify person.
WARNING! It’s very important for system safety and efficiency operation to use appropriate
cable for Grid connection. To reduce risk of injury, please use the recommended proper
cable size as below.
AC Wiring
We recommend using 12AWG wire to the AC terminal block. If the inverter is installed
farther than 70 feet from main power source, wire gauge must be sized properly to avoid
big voltage drops. Be sure all wiring is UL compliant, call our tech support if you are not
sure how to wire any part of the inverter.
WARNING! It’s very important to do the wiring correctly on battery terminals and high
voltage AC side.
120V AC 60Hz 1000W
L L N N
INPUT OUTPUT
RLY 1
COMMON
N.O.
RLY 2
COMMON
N.O.
AC Wiring (120VAC, Single phase, 60Hz)
Input: Hot line +Neutral (Main Source)
Output: NHot line +Ground (Load)