Alkin W3 Series, Инструкция по эксплуатации и перечень запасных частей

Страница: 22 / 83

W 3 S E R I E S
H I G H P R E S S U R E A I R C O M P R E S S O R
©ALKIN COMPRESSORS
17
-Flywheel-side panel not properly placed in its place
-Phase Protection Relay tripped
-Fan motor overload tripped
-Motor overload tripped
-High discharge air temperature
-High rotor winding temperature
Low Oil Level LED If the LED is lit, it indicates that the oil in the
compressor crankcase has diminished.
5
ON Button (Green) Turns the compressor on
Reset Button (Red) Turns the compressor off
6 Digital Thermostat Turns the compressor off when the temperature of
the compressor outlet air reaches to the set value
7 Temperature Indicator Indicates the compressor outlet temperature
8 Set Key Enables to adjust the set value for the compressor
outlet temperature. Set Key is pressed and hold for
this procedure.
9 Adjusting Keys Enables to reduce or increase the value when
adjusting the set value
10 1 st Stage Pressure Gauge Indicates the first stage compressor pressure
11 2 nd Stage Pressure Gauge Indicates the second stage compressor pressure
12 3 rd Stage Pressure Gauge Indicates the third stage compressor pressure
13 Main Switch It is the main member that turns the power to the
compressor on/off
2.5 Description of Controls
2.5.1 Compressor Controls
The W3 Series compressor may operate with the following two controls:
Automatic Start – Stop Control:
This is the standard control type for all single pressure compressor systems. With this type of control, once the
compressor is manually started, it will run till it reaches the high set pressure where is will automatically stop (the
pressure where the motor will cut-out); after the pressure drops to the low set-pressure (the pressure where the motor
will cut in), it will automatically re-start. This control system is standard on all single pressure compressors.
Drain Control:
W3 Series compressors can be automatically drained by automatic drain valves. These drain valves
are controlled by 3 way Solenoid Valve which is normally closed. This solenoid valve supplies or
cuts the control air on the drain valves, thus letting them to open or close. The solenoid valve itself
is controlled by a timer installed in the electrical panel. The dual time adjustment on this timer
allows to adjust the time period (t1~7 min) which the solenoid will remain energised (=the drain
valve will remain closed), and the duration( t2 ~ 6 seconds) during which the solenoid will be de-
energised (=the drain valve will open and perform the drain function).
Important !
Do not change the factory settings of the drain times and durations. Consult the factory if you need to
change the settings.