16
Basic Operations
5
To Receive Signals
1.
Turn on and adjust audio/squelch levels.
2.
Select your desired frequency.
When a signal is received at your
desired frequency,
will light up
and receiving sound will be heard. The
S-meter will swing according to the
receiving signal strength.
Monitoring Function
This function allows you to cancel the squelch operation so that weak
signals that are below the squelch level can be heard.
1.
Press and hold the
SQL
key for 1 second or press MIC"s
key.
will appear and the squelch
opens.
2.
To cancel the monitoring function, press
[PTT] key or any key on the unit except
for the knob.
To Transmit Signals
1.
Select your desired frequency.
2.
Press the [PTT] key on the microphone.
The TX indicator lights red and starts
transmitting.
3.
While pressing the [PTT] key, speak
into MIC in a normal voice.
Place the microphone about 5 cm away
from your mouth when you speak.
VOL
PWR
TX
SET
FUNC
MW
V/M
LOCK
TS/DCS
H/L
CALL
TX
Release the [PTT] key to return to receiving mode.
Pressing the [PTT] and [DOWN] keys simultaneously will transmit a
tone call signal.
When the auto-dialer is set, pressing the [PTT] and [UP] keys
simultaneously will transmit the auto-dialer signal set in advance.
When the 2Tone is set, select a mode other than menu mode, then
while pressing the
FUNC
key, press Dial. The icon will light up
and the transceiver will enter 2Tone mode. Press [PTT] to transmit
2Tone which is set in advance.
If the [PTT] key is pressed outside of the transmission frequency
range, [OFF] will appear on the display and warning beep sounds
until the [PTT] is released. Enter within the transmitting frequency
range to resume transmitting.
CALL mode
This is a memory mode that allows the transceiver to quickly recall the
assigned memory channel by simply pressing the
CALL
key, regardless
of the current status of the unit.
1.
Press
CALL
key. The icon appears on
the display and the transceiver enters
the CALL mode. In this mode, the main
dial or the [UP]/[DOWN] keys cannot change the frequency or
memory channels.
2.
Press
CALL
key again or press
V/M
key to exit CALL mode.
3.
No scan functions are available in CALL mode.
To store a desired setting in the CALL channel, follow the memory
mode programming instructions and assign your selected settings
to memory channel C. The call channel can be modified but cannot
be eliminated or hidden.
