14
• CTCSS tone both encode and decode
• DCS code both encode and decode
• Scan skip
• Busy Channel Lock Out setting
• Normal/Narrow FM width
P1 and P2 can be used as memory channels, but only
frequency will apply during the programmed scanning,
disregarding settings like tone and shift.
CHANNEL DISPLAY MODE
Call up and operate frequencies or settings registered in advance.
Channels set in memory mode or with a PC application will appear.
If you enter to the Channel display mode without programming any
memory channel, it will display CALL channel only.
1.
To switch to channel display mode from VFO mode or memory
mode, turn off the power, then turn on the power again while
pressing the
V/M
key until a beep sounds.
The unit enters the channel display
mode.
2.
Rotate the dial or press the [UP]/
[DOWN] key on the microphone to
select a memory channel.
3.
To switch to VFO mode or memory mode from channel display
mode, turn off the power, then turn on the power again while
pressing the
V/M
key until a beep sounds.
The unit enters the VFO mode or memory mode.
4
Operating Modes (VFO Mode, Memory Mode, Channel Display Mode)
This mode is like a landmobile radio, allowing users for
communications only prohibiting accesses to parameter setting
modes. The reset is also prohibited in this mode, therefore, you
should resume VFO/memory mode before resetting.
