1. Lay the computing unit face down
on a smooth, flat surface.
Remove the 4 screws with a Phillips
screwdriver, while holding and
moving the handle, as required.
2. Remove the iTero back cover plate
to expose the VESA screw holes. (It
is recommended to store the cover
plate and screws in the trolley.)
3. Connect the computing unit to the
external VESA mount (VESA 100)
using the screws supplied with the
mounting solution.
Optional: You can purchase a 3m
power cable from Align, if required.
4. Slide the cradle on the slider on the
side of the computing unit until it
clicks into place. Make sure the
cradle is secure and cannot be
pulled off.
5. Place the wand in the cradle and
connect the wand cable to the port
marked
at the back of the
computing unit.
6. Connect the power cable.
Note:
Make sure that the power
pack is on the floor or a table, and
does not dangle in the air.
iTero Element 5D and iTero Element 5D Plus imaging systems User manual
© 2022 Align Technology, Inc. All rights reserved.
31
