Align-Pilates C1-Pro Reformer, Инструкция по сборке и руководство пользователя

Страница: 5 / 12

5
Move the gear bar to the position nearest the standing platform and move the carriage stopper to the
corresponding position so the bed is rolled to furthest point toward the foot end of the reformer (Fig.11).
Now attach all the springs to the relevant hooks on the gear bar to stop the carriage rolling (Fig.12). Take
each rope and loop them over the upright rope holder on the shoulder rests. Take the end of each
corresponding rope and thread these through each of the pulleys.
For the next part we recommend standing the reformer up, with the assistance of another person, so that
they can hold the machine whilst you make the required adjustments.
Once you are in position, from
the underside of the reformer pull each rope tight, then knot each
rope so that the knot is flush against the tube as shown in (Fig.13).
Repeat for the second rope and then check that the ropes are
adjusted to exactly the same length, if they are not; adjust one or
both of the knots, the ropes should be taught with the rope
handles on the shoulder rests. When both ropes are the same
length and pulled tight, tie an extra knot in the end of the rope for
safety. The ropes tails can be coiled around the T bar to get them
out the way.
8. Foot Strap installation:
1) Separate the strap in to 2 parts. Taking one half of the strap,
thread the nylon loop through the eyelet on the reformer frame under the jump board (Fig. 14)
2) Now pass the foot strap through the loop and pull tight (Fig. 15)
3) Repeat this process for the other half of the strap (Fig. 16) and finally re-thread the strap through the
D-ring (Fig. 17) and the strap is ready to use (Fig.18).
9. How to adjust the foot strap:
To tighten - simply pull on the end of the strap.
To loosen - first loosen the strap at the D-ring and then the strap can be pulled out to be lengthened.
The strap can be used either between the legs (above the cross support and below the jump board) or
around the outside of the jump board, according to your preferred pull position.
Congratulations! You are now ready to use your C1-Pro Reformer. Now would be a good time to make a
note to replace your springs in 2 years or, within 3,000 hours of use, whichever is sooner. We hope that you
enjoy using your new C1-Pro reformer!
Fig.13
Fig.14 Fig.15 Fig.16
Fig.17 Fig.18
End Stopper
Fig.12
Gear Bar
Fig.11
Carriage Stopper
x4 Carriage
Stopper Positions