Align-Pilates C1-Pro Reformer, Инструкция по сборке и руководство пользователя

Страница: 3 / 12

3
Using the allen bolts and a 6mm Allen key, screw in the 5 bolts per leg and hand tighten. Be careful not to
cross thread the bolts. Once all the bolts are in, tighten fully with the Allen key.
After removing your trestles or other elevation device, put your reformer down where you intend to use it.
Then use a spirit level to check the reformer is level and stable. Adjust the level of the reformer by turning
the rubber feet in or out.
Tip: Always lower a high foot before raising a low foot.
Maintenance: Periodically check all bolts that attach the legs to the reformer are tight.
For further
information on maintenance please see point 10.
3. Insert the Reformer Carriage
With the reformer back on the floor, carefully remove the carriage from its packaging. With one person
holding each side of the carriage gently slide the carriage in to the runners with the springs pointing to-
wards the standing platform. Be very careful not to damage the wheels when sliding in to the runners.
Fig.1
Ref Code Name Specification Qty
1 1L Left leg standing platform end 1
2 1R Right leg standing platform end 1
3 2R Right leg rope riser end 1
4 2L Left leg rope riser end 1
5 Flat washer 8.5*20*T1.5 20
6 Spring washer 8.3*12.7*T2.0 20
7 Bolt M8*20 20
2. Attaching the optional extension legs (optional extra)
If you have bought extension legs for your C1-Pro it is best to fit these first. We recommend getting a pair of stable
trestles to put the reformer on to enable easy fitting of the legs. Place the trestles 120cm apart and make sure the
top of the trestles have something soft on them to avoid scratching the reformer frame. Lift the reformer out of the
box and place it gently onto the trestles, so one of the trestles is underneath the point where the foot bar attaches to
the aluminium runner.
Remove the wheels at the foot end of the reformer, placing all nuts, bolts and washers to one side. Store the parts in
the order you removed them and then reinstall the wheels on to the higher legs. Remove all four of the black
adjustable screw in feet by unscrewing them completely out and then screw these completely in to the C1-Pro leg
extensions. For further information see the exploded diagram in Fig.1
below.
Rope Pulley
Rope Riser
Adjustable Feet
Carriage Bed
Removable Shoulder Rests
Rope Holder
End Stopper
Silent Straps & Ropes
Footbar
Standing
Platform
Jump Board
Fastener
Footbar Selector
Rope Riser
Adjustment Knob
C1-Pro Reformer Map: