4
Locate the CMOS jumper (CLEAR_CMOS1) on the system board. See
“
System-Board Components
”.
5
Remove the jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
6
Wait for approximately five seconds to clear the CMOS setting.
7
Remove the jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
1
pin 1
2
pin 2
3
pin 3
4
jumper plug
8
Replace the left side-panel. See "
Replacing the Side Panels
”.
9
Replace the
stability foot
.
Flashing the BIOS
You may need to flash (update) the BIOS when an update is available or when
you replace the system board. To flash the BIOS:
1
Turn on the computer.
2
Go to
dell.com/support
.
3
If you have your computer's Service Tag, type your computer's Service Tag
and click
Submit
.
If you do not have your computer's Service Tag, click
Detect My
Product
to allow automatic detection of the Service Tag.
NOTE: If the Service Tag cannot be detected automatically, select
your product under the product categories.
4
Click
Get Drivers and Downloads
.
5
Click
View All Drivers
.
6
In the
Operating System
drop-down, select the operating system
installed on your computer.
7
Click
BIOS
.
132
Содержание Area-51 R2
