Manual
TdC 8001
-27-
4 Special Functions
4.1 Test – Check TdC 8001
See chapter 6.13
4.2 Block – Deactivate Impulse Channels
Every channel (C0 - C9) can be activated/ deactivated. Two possibilities exist to deactivate a channel:
−
The deactivated channel ignores any impulse; the time is not recorded (channel off)
−
The deactivated channel marks every impulse as invalid (with b), saves and prints the time.
Nothing is displayed on the scoreboard.
The channels 0 and 1 can be activated and deactivated directly.
4.2.1 Block Start
−
As long as <BLOCK> of the start keypad (12) is pressed, all start impulses (channel 0) are
invalid and indicated with b.
Printer:
b0043 SZ
10:34:13.384
Display Board:
no output
RS232:
b0043 C0
10:34:13.384(CR)
−
As long as <ALT> and <BLOCK> of the start keypad (12) are both pressed, all start impulses
(channel 0) are ignored. No times are saved or output. A blocked start impulse does not trigger
the time.
4.2.2 Block Finish
−
As long as <BLOCK> of the finish keypad (8) is pressed, all finish impulses (channel 1) are
invalid and indicated with b. The clock does not stop and no run time is saved.
Printer:
b0043 ZZ
10:34:13.384
Display Board:
no output
RS232:
b0043 C1
10:34:13.384(CR)
−
As long as <ALT> and <BLOCK> of the finish keypad (8) are both pressed, all finish impulses
(channel 1) are ignored. No times are saved or output; no output on the scoreboard if a stop
impulse is triggered while pressing <BLOCK>.
4.2.3 Individual Setting of Channels
All 10 channels can be activated or deactivated individually. All channels are activated when turning on.
(Exception: continuation in a heat or selection of the next heat.)
−
Pressing both <MENU> and <BLOCK> shows the state of all channels in info display (7).
−
Select the desired channel with
and
.
−
Change state of channel with F1
−
(+) means the channel is activated
−
(-) means the channel is deactivated
−
Leave the menu by pressing both <MENU> and <BLOCK>
Example for display on info display (7):
channels on (+)/off (-):
CHANGE
F1
F2
F3
+ + + + + + + + + +
F4
c0 c1 c2 c3 c4 c5 c6 c7 c8 c9
The above shown setting is always this after turning on the device (if not a further heat was selected).
The below example show channel c3 and c4 deactivated.
channels on (+)/off (-):
CHANGE
F1
F2
F3
+ + + - - + + + + +
F4
c0 c1 c2 c3 c4 c5 c6 c7 c8 c9
Содержание TDC8001
