Copyright
2005 Alfano, S.A. All rights reserved.
13
8
Press the left button to regulate:
>>
The HIGH level of P1.
9
Continue to press or successively press
the right button on the UP arrows:
>>
To increase the level.
10
Continue to press or successively press
the right button on the DOWN arrows:
>>
To reduce the level.
11
Press the left button to regulate:
>>
The LOW level of P2.
Continue the same operations to regulate the levels of:
P2: LOW and HIGH
12
Press the left button:
>>
To exit.
NOTE: in the STOP and START modes:
The pressures are lower than the BAD levels
=
the detector lights ARE BLINKING.
The pressures are higher than the HIGH levels
=
the detector lights REMAIN ILLUMINATED.
NOTICE: The activated pressure sensors replace the temperature sensors « NTC ».
P1 activate takes over the place of T1 « NTC »
P2 activate takes over the place of T2 « NTC »
Menu 18 :
SPEED Config
Configuring the length of the wheel circumference:
NOTE: as for the AStrO LVF, it is necessary to connect a speed sensor.
1
Press the right button:
>>
To enter the menu.
2
Continue to press or successively press
the right button on the UP arrows:
>>
To decrease the circumference.
3
Continue to press or successively press
the right button on the DOWN arrows:
>>
To increase the circumference.
4
Press the left button:
>>
To exit.
NOTE: the measure is represented either in "metric" millimeters or in "imperial" inches according to the
configuration in menu 31.
IMPORTANT: It is absolutely necessary to connect the speed sensor to draw the trajectory with the
software "VISUALDATA".
Menu 19 :
GEARBOX
Configure the transmission ratios. NOTE: the configuration is done while driving normally.
1
Press the right button:
>>
To enter the menu.
2
Drive in 1
st
gear:
>>
The system automatically configures the
ratio of box n°1.
